#include <stdio.h>
#include <stdlib.h>
#include <pic.h>
#include <xc.h>

#pragma config FOSC = INTOSCIO  // Oscillator Selection bits (INTOSC oscillator: I/O function on RA6/OSC2/CLKOUT pin, I/O function on RA7/OSC1/CLKIN)
#pragma config WDTE = ON       // Watchdog Timer Enable bit (WDT disabled)
#pragma config PWRTE = ON       // Power-up Timer Enable bit (PWRT enabled)
#pragma config MCLRE = OFF      // RA5/MCLR/VPP Pin Function Select bit (RA5/MCLR/VPP pin function is digital input, MCLR internally tied to VDD)
#pragma config BOREN = ON       // Brown-out Detect Enable bit (BOD enabled)
#pragma config LVP = OFF        // Low-Voltage Programming Enable bit (RB4/PGM pin has digital I/O function, HV on MCLR must be used for programming)
#pragma config CPD = OFF        // Data EE Memory Code Protection bit (Data memory code protection off)
#pragma config CP = OFF         // Flash Program Memory Code Protection bit (Code protection off)


#define Button1 RA3
#define Button2 RA4
#define Button3 RA5
#define Button4 RB0
#define Button5 RB1
#define Button6 RB2
#define Button7 RB3
#define Button8 RB5
#define Button9 RB4

#define DISP1 RB7
#define DISP2 RB6
#define DISP3 RA1
#define DISP4 RA6
#define DISP5 RA0
#define DISP6 RA7
#define DISP7 RA2

void main(void)
{
    CMCON = 0x07;
    TXSTA = 0xFF;
    VRCON = 0xFF;
   
    TRISA = 0b00111000;
    TRISB = 0b00111111;
   
    for(;;){
        if (Button1 == 1) {
        DISP1 = 1;
        DISP2 = 1;
        DISP3 = 1;
        DISP4 = 1;
        DISP5 = 1;
        DISP6 = 1;
       
        } else {
            DISP1 = 0;
            DISP2 = 0;
            DISP3 = 0;
            DISP4 = 0;
            DISP5 = 0;
            DISP6 = 0;
        }
    }
   
}

#define sw RB3
#define led RA1
#define led2 RB4
void main(void)
{   
   
    TRISA = 0;
    TRISB = 1;

    for(;;){
   
    if (sw == 1) {
        led = 1;
    } else {
        led = 0;
        led2 = 1;
    }
    }
   
}