OpenCooltroniCtrl.c
72:     HANDLE hSerial=openport("COM7");

openport.c
6: HANDLE openport(char portname[4])

What do you like me to do?
a - start debug          b - end debug   g - get debug output
r - read value           w - write value
m - monitor temp         t - read temp continuously
p - change port          q - Quit
p
Serial port is not initializable (does not exist)An error - whatever it is - ocurredThe system cannot find the file specified.

Can't get parameters of the serial port.
Am not able to set port state.

What port shall I use?
1 or 5
1
COM1COM1 is initialized